Inertia Zero Offset Forks use Coned tubing. This reduces the weight dramatically but distributes the strength to where it is needed the most. A one-piece machined steerer tube that is thinned out as much as possible and fork legs that cone from 28mm down to 25 mm give a clean streamlined look. The forks look better proportioned and more in-line with the rest of the bike as their size is similar to the size of the tubing on the chain stays. Laser-cut dropouts have been configured so that the exact amount of surface area required for full contact between the cone nuts and the dropouts is achieved. Inertia�s signature recessed section is also incorporated cut into the inside of the dropout. This takes out any excess metal but allows for full contact with the peg on the outside of the dropout.
-18mm vent holes and crescent shaped cut-out.
-Capped and polished tapers.
-These unique features make Inertia's forks unparalleled in design and push innovation to the next level.
-Available in Matte black or Grey
-Available with brake mounts or with out brake mounts
-Steerer tube length 175mm
-alloy headset pre load bolt easily allows 2 brake cables to pass through if you run dual front brakes
-available with 3/8" or 14mm dropouts

*28.4oz/805g